Rhino 3D Video Tutorial – Modelling a cup using Subdivision

This video demonstrates the modelling of a simple organic cup using Rhino 3D’s Subdivision capability. Compared to traditional NURBS techniques. Subdivision modelling is actually easier to understand. However, as of this writing, subdivision modelling is not officially supported in Rhino 6. Additionally, it still is lacking some standard tools such as loop cuts, knife tools which are very useful for this kind of work.

Key commands used in the video demo are:

    • Gumball Face Extrude
    • 3D Face
    • Subdfrommesh

Enjoy the video tutorial 🙂

This video recording is done by Studiorola.

Leave a Reply

Your email address will not be published. Required fields are marked *