Sleek Plus Kettle

This is a Product Design project that was done in the late 1990s.

The project calls for the redesign of an existing kettle. Some of the internal elements were to be retained while the outer form needed a new look to re-address a different market group.

sleekkettle.jpg

For this project, CAD modeling was done using Rhinoceros 3D and Pro/Engineer. Technical surfacing was done mainly on Rhinoceros 3D. The completed surfaces were then imported into Pro/Engineer for parts, assembly and 2D associative technical drawing creation.

explodekete.jpg

Leave a Reply

Your email address will not be published. Required fields are marked *